Lucent Technologies PARTNER Advanced Communications System Release 1.0 Installation Manual page 34

Replacing Modules in a 5-Slot Carrier
WARNING:
Before starting, verify that you have charged batteries installed in the PARTNER ACS
processor module, and then disconnect the power cord from the power jack on the carrier.
1
A) Move the carrier's On/Off switch to the "Off" position
("O").
B) Loosen the screw on the lower front of the
carrier's cover. Then place one hand on the
handle on the lower front and place your other
hand on the top of the cover.
C) Gently pull the cover up and away from the
carrier—be careful not to break the tabs that
attach the cover to the carrier.
2
Before installing a module, make sure the clear, plastic
protector has been removed from the connector
area on the rear of the module. To remove the
protector, grasp the tabs on the ends of the
protector and lift.
3
A) Check the slack in the wires. If there is not
enough slack to remove the module without
pulling the line and extension cords free,
label and disconnect the wires before
continuing with Step 3B.
B) Place one hand on top of the module. With your
other hand, grip the plastic bracket on the
bottom front of the module, and pull out the
old module.
C) If you are replacing a module with one of a
different type, make sure that all 400 (or 200)
modules are installed to the right of all 206
modules and that the PARTNER ACS
processor module remains in the center slot.
D) To insert the replacement, push slowly but firmly
in the center of the module until the module
locks into place and is attached to the rear of
the carrier. Do not force the module. If the
module does not insert easily, remove it, clear
any obstruction, and reinsert it.
30 Equipment Upgrades
On/Off Switch
PFT
L
1
I
N
E PFT
2 3 L
S I
N
PFT
4 E L
S PAGE
I
N
E PFT
5 L
S
206 I
MODULE N
6 E
206 S
MODULE
PFT PROCESSOR
10 MODULE
PFT
11 E 16 206 206
MODULE MODULE
X
T
12 E 17 E
N X
S T
13 18
I E VOL
O N
14 N 19 S
I
S
O MUSIC
ON
15 20 N HOLD
S
21
Handle
Screw
Tab
Tab
PFT
L
I
N
E
S
206
MODULE
PFT
E
X
T
E
N
S
I
O
N
S
Power
Jack