Wall-Mounting A 2-Slot Carrier And Modules - Lucent Technologies PARTNER Advanced Communications System Release 1.0 Installation Manual

3
A) Label the line and extension jacks as shown.
B) If you are installing a two-module system,
continue with "Wall-Mounting a 2-Slot Carrier
and Modules;" otherwise, skip to "Inserting
Batteries in the PARTNER ACS Processor
Module."

Wall-Mounting a 2-Slot Carrier and Modules

To wall-mount a 2-Slot carrier, first follow the instructions in "Wall-Mounting a Stand-Alone PARTNER
ACS Processor Module."
IMPORTANT:
If you are adding a PARTNER ACS processor module to an existing system, you must install the
ACS processor module as the first module. See "Wall-Mounting a Stand-Alone PARTNER ACS
Processor Module" on the previous page for instructions.
You can install a 206, 400, or PARTNER MAIL VS module
as the second module, using the following steps:
1
Remove the clear, plastic protector from the
connector on the right side of the wall-mounted
PARTNER ACS processor module by grasping the
tabs on the ends of the protector and lifting.
2
If this is an upgrade to an existing single-module
system, remove the #8 sheet metal screw from the
bottom of the existing PARTNER ACS processor
module.
3
Remove the clear, plastic protector from the
connector on the right side of the second module.
4
Slide the second module onto the first module,
making sure the pairs of mounting tracks interlock,
as shown in the side view.
Lines
Extensions
Mounting
Tracks
Installation Procedures
Tab
Tab
9