Lucent Technologies PARTNER Advanced Communications System Release 1.0 Installation Manual page 17

3
Remove the battery assembly by gently pulling the tab
at the bottom of the battery compartment cover.
4
Insert two new AAA-size standard alkaline batteries
into the metal spring clips by pushing them straight
in, placing the negative (–) end of one battery into
the bottom clip, and the positive (+) end of the
other battery into the top clip.
5
With the locking latch in the unlocked position (battery
icon and "minus" icon visible), slide the battery
assembly into the processor module along the
battery guides on the inside of the battery
compartment.
6
Make sure the battery assembly is pushed in far
enough that the edges of the assembly slip behind
the plastic housing of the processor module.
7
Pressing lightly on the battery icon on the front of the
battery assembly, slide the locking latch downward
to secure the assembly in place. The "plus" icon
and the battery icon should now be visible on the
front of the battery assembly. This is the locked
position.
Tab
Tab
Locking Latch
Unlocked
Position
Locked
Position
Installation Procedures
Push to
insert
13