Replacing System Modules - Lucent Technologies PARTNER Advanced Communications System Release 1.0 Installation Manual

Replacing System Modules

The procedure for replacing a module depends on your configuration:
If you have a...
Stand-Alone PARTNER ACS processor module
configuration
2-Slot carrier configuration
5-Slot carrier configuration
Replacing a Stand-Alone PARTNER ACS Processor Module
WARNING:
Before starting, verify that you have charged batteries installed in the PARTNER ACS
processor module, and then disconnect the power cord from the power jack on the
processor module. For an illustration showing the location of the power jack, see
"Powering Up the System" earlier in this guide.
1
Check the slack in the wires. If there is not enough
slack to remove the module without pulling the line
and extension cords free, label and disconnect the
wires before continuing.
2
Remove the screws at the top and bottom of the
module, and remove the module from the wall.
3
Follow the instructions in "Wall-Mounting a
Stand-Alone PARTNER ACS Processor Module"
and "Inserting Batteries in the PARTNER ACS
Processor Module," earlier in this guide.
4
Connect the line and extension cords one at a
time, making sure to place the correct cords into
their corresponding jacks on the new module.
(See "Connecting Lines and Extensions" earlier in
this guide.)
5
Reconnect the power cord.
See...
"Replacing a Stand-Alone PARTNER ACS Processor
Module"
"Replacing Modules in a 2-Slot Carrier"
"Replacing Modules in a 5-Slot Carrier"
Equipment Upgrades 27