Assigning Features To Programmable Buttons - AT&T MERLIN 3070 Administration Manual

ASSIGNING FEATURES TO PROGRAMMABLE BUTTONS

As system administrator you may have to decide which custom features certain voice
terminals should have, taking into consideration the individual's needs and the
capabilities of the voice terminal. The Feature Programming Chart, pages 36 and
37, lists the programming codes you use to assign the features, and the initial feature
assignments diagrams, pages 29, 44, and 45, show what features are automatically
assigned to the voice terminals. Before assigning features, please read the follow-
ing information.
Some features require buttons with lights to indicate whether the feature is ac-
tivated. These features are Do Not Disturb, Privacy, Auto Answer-Intercom, Auto
Answer-Outside, Shift and Ring Option Override.
A button with lights is recommended but not required for the Auto Intercom and
Loudspeaker Page features.
Now, follow the procedure below.
1.
Go to the voice terminal you want to program.
2. Label the button(s) with the name of feature(s) you want to program.
3. Slide the T/P switch on the left side of the voice terminal to P.
The voice terminal rings every 5 seconds to remind you it is in program mode.
4. Touch the button that you have labeled.
5. Dial the appropriate feature programming code and any additional numbers
or characters, if required, from the Feature Programming Chart, pages 36
and 37. If you make a mistake, touch the button again and redial the
information.
6. If you have more features to assign, you can do so by repeating steps 4 and
5. Otherwise, slide the T/P switch to the center position to return to normal
operation.
35