Dell PowerConnect J-Series J-EX8216 Ethernet Switch Hardware Guide
Related
Documentation
Installing the Power Cord Tray in a Rack or Cabinet for a J-EX8200 Switch
106
Use 4 mounting screws appropriate for your rack—plus washers if you installed cage
13.
nuts—to attach the right rear bracket to the rack.
Connect the right front and rear brackets (see Figure 39 on page 105):
14.
Insert 6 of the screws provided with the mounting brackets into the overlapping
a.
bracket holes.
Hand tighten the screws fully (to 12–16 in.-lb torque) using a number 2 Phillips
b.
screwdriver.
Figure 40: Adjustable Mounting Brackets Installed in a Four-Post Rack
(J-EX8216 Switch)
Mounting a J-EX8216 Switch on a Rack or Cabinet on page 108
The power cord tray is supplied with all J-EX8200 switches. The power cord tray is
optional for four-post rack or cabinet installation. (The remainder of this topic uses "rack"
to mean "rack or cabinet.")
NOTE: The J-EX8216 switch can be installed only in a four-post rack.
Installation in a two-post rack is not supported.
The power cord tray provides a place to organize and tie down the power cords for the
power supplies.