Installing The Hardware; Installing The Chassis In A Rack Or Cabinet - Dell Force10 S60 Quick Start Manual

Hide thumbs Also See for Force10 S60:

Table of Contents

Installing the Hardware

This guide assumes all site preparation has been performed before installing the

chassis.

To install the S55 or S60 systems, Dell Force10 recommends that you complete

the installation procedures in the order presented below.

NOTE: Unless stated otherwise, the installation instructions below apply to both

the S55 and S60 chassis.

Always handle the system and its components with care. Avoid dropping the

switch or its field replaceable units.

CAUTION: Always wear an ESD-preventive wrist or heel ground strap when

handling the chassis and its components. As with all electrical devices of this

type, take all necessary safety precautions to prevent injury when installing

this system. Electrostatic discharge (ESD) damage can occur if components

are mishandled.

Attaching Mounting Brackets

The chassis is shipped with mounting brackets (rack ears) and required screws

for rack or cabinet installation. The brackets are enclosed in a package with the

chassis.

NOTE: Dell Force10 recommends attaching the brackets at the PSU side. This

provides the greatest weight support for the chassis in the rack or cabinet.

Step

Task

Take the brackets and screws out of their packaging.

Installing the Hardware

Table of Contents

Show Quick Links

Table of Contents

Force10 s55