Dell PowerConnect J-EX8216 Hardware Manual page 54

Dell PowerConnect J-Series J-EX8216 Ethernet Switch Hardware Guide
Table 19: Network Port LEDs on Line Cards in a J-EX8200 Switch—Link/Activity LED
LED
Link/Activity
Table 20: Network Port LEDs on Line Cards in a J-EX8200 Switch—Status LED
LED
Status
Related
Documentation
38
Color
Green
The LEDs labeled Status in Figure 21 on page 37, Figure 22 on page 37, and Figure 23 on
page 37 indicate the status of one of the three port parameters. The port parameters are
administrative status, duplex mode, and speed.
Table 20 on page 38 describes the Status LED. From the Idle menu of the LCD, use the
Enter button on the LCD panel to toggle between the ADM, DPX, and SPD indicators.
LCD Indicator
LED: ADM
LED: DPX
LED: SPD
8-port SFP+ Line Card in a J-EX8200 Switch on page 32
48-port SFP Line Card in a J-EX8200 Switch on page 33
48-port RJ-45 Line Card in a J-EX8200 Switch on page 34
State and Description
On steadily—The port and the link are active, but there is no
link activity.
Blinking—The port and the link are active, and there is link
activity.
Off—The port is not active.
State, Color, and Description
Indicates the administrative status (enabled or disabled). The
status indicators are:
Green—Administrative status enabled.
Unlit—Administrative status disabled.
Indicates the duplex mode. The status indicators are:
Green—Port is set to full-duplex mode.
Unlit—Port is not set to full-duplex mode.
Indicates the speed. The speed indicators are different in the
line cards.
The speed indicators for 8-port SFP+ line cards are:
Unlit—Less than 10 Gbps
Green—10 Gbps
The speed indicators for 48-port SFP line cards are:
Unlit—Less than 1 Gbps
Green—1 Gbps
The speed indicators for 48-port RJ-45 line cards are:
Unlit—10 Mbps
Green—Blinking—100 Mbps
Green—On steadily—1000 Mbps