Dell PowerConnect J-EX8216 Hardware Manual page 39

Table 11: LCD Panel Menu Options for the J-EX8200 Switch (continued)
Menu Description
Maintenance The Maintenance menu has the following options:
SYSTEM HALT?—Choose one of the following:
Press
In a redundant configuration, the backup SRE or RE module takes over mastership when the master SRE
or RE module is halted. To completely halt the switch, use the
CLI command to halt the backup SRE or RE module before halting the master SRE or RE module. Press
on your management device or power cycle the switch to bring the switch back up.
Enter
Press
SYSTEM REBOOT?—Choose one of the following:
Press
Press
LOAD RESCUE?—Choose one of the following:
Press
rollback.
Press
FACTORY DEFAULT?—Choose one of the following:
Press
restoration. The LCD flashes a success or failure message and returns to the Idle menu.
Press
ENTER EZSETUP?—Choose one of the following:
Press
EZSetup configures DHCP and enables the J-Web user interface on the switch. The LCD flashes a success
or failure message for approximately 10 seconds and returns to the Idle menu.
Press
NOTE: You can use the EZSetup option only if the switch is in the factory default configuration.
EXIT MAINT MENU?—Choose one of the following:
Press
Press
If you do not want users to use Maintenance menu options, disable the entire menu or individual menu options.
For instructions, see the Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS at
http://www.support.dell.com/manuals
Related
Documentation
to halt the master RE module in a J-EX8216 switch. Press
Enter
to go to the next option in the Maintenance menu.
Menu
Enter to reboot the master SRE or RE module. Press
to go to the next option in the Maintenance menu.
Menu
to roll back the switch to the previous valid configuration. Press
Enter
to go to the next option in the Maintenance menu.
Menu
to restore the switch to the factory default configuration. Press
Enter
to go to the next option in the Maintenance menu.
Menu
Enter to launch EZSetup. Press
Menu to go to the next option in the Maintenance menu.
Enter to exit the Maintenance menu.
to return to the SYSTEM HALT option.
Menu
You can view the information about the LCD panel in J-EX8200 switches by executing
the command
show chassis hardware
and description of the LCD panel.
Chassis Status LEDs in a J-EX8200 Switch on page 24
Field-Replaceable Units in a J-EX8216 Switch on page 25
Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 144
Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 146
request system halt other-routing-engine
Enter again to confirm the reboot.
Enter again to confirm the launch.
.
. It shows the version, part number, serial number,
Chapter 2: Component Descriptions
again to confirm the halt.
Enter
again to confirm the
Enter
again to confirm the
Enter
23