48-Port Rj-45 Line Card In A J-Ex8200 Switch - Dell PowerConnect J-EX8216 Hardware Manual

Dell PowerConnect J-Series J-EX8216 Ethernet Switch Hardware Guide
Related
Documentation

48-port RJ-45 Line Card in a J-EX8200 Switch

34
Figure 16: 48-port SFP Line Card
The line card has two status LEDs labeled ON and ST on the faceplate that indicate the
online and status information for the line card. See "Line Card LEDs in a J-EX8200 Switch"
on page 35.
8-port SFP+ Line Card in a J-EX8200 Switch on page 32
48-port RJ-45 Line Card in a J-EX8200 Switch on page 34
Optical Interface Support in J-EX8200 Switches on page 51
Installing a Line Card in a J-EX8200 Switch on page 123
Handling and Storing Line Cards in J-EX8200 Switches on page 175
The line cards in J-EX8200 switches combine a Packet Forwarding Engine and Ethernet
interfaces on a single assembly. They are field-replaceable units (FRUs) that can be
installed in the line card slots on the front of the switch chassis. The line cards are
hot-insertable and hot-removable: You can remove and replace them without powering
off the switch or disrupting switch functions.
J-EX8200 switches use the following types of line cards:
8-port SFP+ line card
48-port SFP line card
48-port RJ-45 line card
You can use any combination of line cards in a J-EX8200 switch.
The 48-port RJ-45 line card for J-EX8200 switches (see Figure 17 on page 35) has 48
10/100/1000 Gigabit Ethernet ports with RJ-45 connectors on the faceplate. Each port
has two LEDs. See "Network Port LEDs in a J-EX8200 Switch" on page 36.