Grounding Cable And Lug Specifications For J-Ex8200 Switches - Dell PowerConnect J-EX8216 Hardware Manual

Table 29: Optical Interface Support and Copper Interface Support for SFP Transceivers in
48-port SFP Line Cards Used in J-EX8200 Switches (continued)
Ethernet Standard Specifications
1000Base-LH (also Model Number
called 1000Base-ZX)
Rate
Connector Type
Transmitter Wavelength
Minimum Launch Power
Maximum Launch Power
Minimum Receiver Sensitivity
Maximum Input Power
Fiber Type
Core Size
Modal Bandwidth
Distance
DOM Support
Software required
Related
Documentation

Grounding Cable and Lug Specifications for J-EX8200 Switches

8-port SFP+ Line Card in a J-EX8200 Switch on page 32
48-port SFP Line Card in a J-EX8200 Switch on page 33
48-port RJ-45 Line Card in a J-EX8200 Switch on page 34
For show interfaces diagnostics optics
J-Series Ethernet Switch Complete Software Guide for Junos OS at
http://www.support.dell.com/manuals
Installing a Transceiver in a J-EX Series Switch on page 126
Removing a Transceiver from a J-EX Series Switch on page 168
For installations that require a separate grounding conductor to the chassis, the switch
must be adequately grounded before power is connected to ensure proper operation
and to meet safety and electromagnetic interference (EMI) requirements. To ground a
EX-SFP-1GE-LH
1000 Mbps
LC
1550 nm
–2 dBm
5 dBm
–25 dBm
–3 dBm
SMF
10 µm
–
70 km (43.5 miles)
Available
Junos OS for J-EX Series switches
command syntax, see the Dell PowerConnect
.
Chapter 3: Component Specifications
59