AC Power Supply in a J-EX8200 Switch
AC Power Supply Description
Line Card LEDs in a J-EX8200 Switch on page 35
LCD Panel in a J-EX8200 Switch on page 19
This topic describes the AC power supplies in J-EX8200 switches:
AC Power Supply Description on page 39
N+1 Redundancy Configuration of AC Power Supplies on page 40
N+N Redundancy Configuration of AC Power Supplies on page 41
The AC power supplies in J-EX8200 switches are hot-insertable and hot-removable
field-replaceable units (FRUs).
You can install up to six AC power supplies in a J-EX8200 switch. Power supplies are
installed at the bottom of the chassis in slots PSU 0 through PSU 5 (left to right). All
power supplies are accessible from the front of the chassis.
WARNING: The switch is pluggable type A equipment installed in a
restricted-access location. It has a separate protective earthing terminal
provided on the chassis in addition to the grounding pin of the power supply
cord. This separate protective earthing terminal must be permanently
connected to earth ground.
Each AC power supply weighs approximately 7 lb (3.2 kg) and has an independent 16 A
rated AC inlet on its front. Each inlet requires a dedicated AC power feed. Each AC power
supply has an
switch, a fan, and three LEDs on the faceplate that indicate the
Enable
status of the power supply. See Figure 24 on page 39.
Figure 24: AC Power Supply
Chapter 2: Component Descriptions
39