8-Port Sfp+ Line Card In A J-Ex8200 Switch - Dell PowerConnect J-EX8216 Hardware Manual

Dell PowerConnect J-Series J-EX8216 Ethernet Switch Hardware Guide
Table 17: SF Module LEDs in a J-EX8216 Switch
LED (Description)
ST (Status)
SF (Switch Fabric)
Related
Documentation

8-port SFP+ Line Card in a J-EX8200 Switch

32
Color
Green
Yellow
Unlit
Green
Yellow
Unlit
Switch Fabric (SF) Modules in a J-EX8216 Switch on page 29
Installing an SF Module in a J-EX8216 Switch on page 120
Removing an SF Module from a J-EX8216 Switch on page 165
Taking the SF Module Offline in a J-EX8216 Switch on page 164
The line cards in J-EX8200 switches combine a Packet Forwarding Engine and Ethernet
interfaces on a single assembly. They are field-replaceable units (FRUs) that can be
installed in the line card slots on the front of the switch chassis. The line cards are
hot-insertable and hot-removable: You can remove and replace them without powering
off the switch or disrupting switch functions.
J-EX8200 switches use the following types of line cards:
8-port SFP+ line card
48-port SFP line card
48-port RJ-45 line card
You can use any combination of line cards in a J-EX8200 switch.
The 8-port SFP+ line card for J-EX8200 switches (see Figure 15 on page 33) has eight
10-gigabit SFP+ ports on the faceplate in which you can install SFP+ transceivers. The
line card is shipped with dust covers preinstalled in the ports. Each port has two LEDs.
See "Network Port LEDs in a J-EX8200 Switch" on page 36.
State and Description
On steadily—SF module is operating normally.
Blinking—the SF module is in standby mode.
SF module has failed.
SF module is offline.
On steadily—Switch fabric in SF module is operating normally.
Blinking—Switch fabric in SF module is offline.
On steadily—Switch fabric in SF module has failed.
SF module is powered off.