3. Physical installation
Image 3-6
Mounting the XLR adapter
3.1.4
Using the XLR adaptor of the RCU
How to use the XLR adaptor of the remote control unit ?
1. Connect a cable with XLR plug into the XLR adaptor.
2. Connect the other end of the cable with your CLM R10+.
3. Push the XLR adaptor completely against the rugged case of the remote control unit, as illustrated in the left image below, for
wired communication. Pull out the XLR adaptor (about 8 mm) to switch over to wireless communication. (image 3-7)
Image 3-7
3.1.5
RCU usage possibilities
Summarized possibilities
Ref. Possibility description
a.
RCU not wired
b.
RCU wired (mini-jack)
c.
RCU with rugged case not wired
d.
RCU with rugged case wired (mini-jack)
e.
RCU with rugged case and XLR adaptor
pulled out "REMOTE" and not wired
f.
RCU with rugged case and XLR adaptor
pulled out "REMOTE" and wired
g.
RCU with rugged case and XLR adaptor
pushed in "WIRED" and wired
22
C
Comment
Backlight illuminates continuously when wire is connected. Infra red
disabled.
Backlight illuminates continuously when wire is connected. Infra red
disabled.
The XLR adaptor must be in the pulled out position "REMOTE", otherwise
the RCU will not function.
The RCU will send the commands via infra red to the projector.
The RCU will send the commands via the cable connected with the XLR
adaptor to the projector. Backlight illuminates continuously when wire
is connected. Infra red disabled.
S
R59770021 CLM R10+ 11/10/2010
S