Input Module Insertion Into The Projector - Barco ELM R12 Owner's Manual

Connections

Input module insertion into the projector

To insert a module in one of the free slots, handle as follow :
1 Power down the projector and disconnect the power cord from the wall outlet.
2 Remove the dummy plate covering the chosen input slot by turning out both screws.
3 Slide the input module in the free slot. Insure the module is seated correctly in the guide grooves.
4 Press on both handles of the input module until the module plug seats in the connector of the projector.
5 Secure the input module by tightening both retaining screws.
6 Reconnect the power cord to the wall outlet and switch on the projector.
The new installed module can be selected with the digit buttons on the RCU or the local keypad.
Two way
hardwired Hardwired
remote remote
CTRL 2
CTRL 3
Hardwired
remote
CTRL 1
R G B H / C
O n
High Bandwi d th RGB ANALOG INPUT
4-4
Downloaded from ProjectorsManual.com Manuals
Diagnostic Code IR-Rec eiver
Green Operation
Red Stand-by
Sync OK IR O n
RS232/422 IN RS232/422 OUT COMM PORT TRIGGER OUT
R G B V
V H / C
69,'(2
On
High Bandwi d th 5 CABLE INPUT
O U T IN O U T I N
On
T 9 DÃ9 DB DU6 GÃDI Q V U T 9 DÃ9 DB DU6 GÃDI Q V U
R G B V
H / C
9,'(2
O n
W D9@ P DIQ VU
5976072 BARCOELM R12 05052000