Altigen AltiWare OE Release 4.0 Getting Started Manual page 16

Liability & Warranty
d. ALTI-DID0408UD
4. AltiGen Triton cards
a. ALTI-TTAS-12
b. ALTI-TTIP-4
c. ALTI-TTIP-8
d. ALTI-TTT1
e. ALTI-TTRS-12
Operating Software
Provided by AltiGen: AltiWare OE Rev. 4.0 or above.
Power Fail
In the event of a power fail, the first telephone extension on each card
(except for the CD0012UD) is connected directly to the first exchange
line, thus permitting access to dial the emergency services. This telephone
must be powered from the PSTN or have local battery backup capable of
calling the emergency services four hours after the power fail event
occurs.
Wiring
All wiring must conform to National Telecommunications Wiring Regula-
tions and the National Electrical Wiring Regulations.
Additional Requirements for Australia
1. Warning: For safety reasons, connect only ACA or AUSTEL
permitted or certified equipment to the telephone ports (RJ11) of the
patch panel or the audio in/out jacks on the AltiServ card.
2. Warning: THIS EQUIPMENT MUST ONLY BE INSTALLED
AND MAINTAINED BY SERVICE PERSONNEL
Additional Requirements for USA and Canada
1. The interconnecting trunk line cord should be at least size 26AWG.
2. This trunk card must be fitted in host equipment with fire enclosures
complying with the flammability requirements of sub-clause UL1950/
CSA C22: 1995 4.4.3. In addition, the card must be separated from
xvi AltiWare OE 4.0 Getting Started Manual