Ac Power Cable Assembly - Compaq DL580 - ProLiant - 1 GB RAM Maintenance And Service Manual

AC Power Cable Assembly

To remove the AC power cable assembly:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the primary power supply cable
the two rear power outlets. Cut the plastic tie wrap securing the cable if there is one.
Figure 2-38. Removing the AC power supply cables
3. Remove all hot-plug power supplies. See "Hot-Plug Power Supply" earlier in this chapter.
4. Remove all hot-plug fan assemblies. See "Hot-Plug Fan Assemblies" earlier in
this chapter.
5. Remove the PCI guide bracket. See "PCI Guide Bracket" earlier in this chapter.
6. Remove the center wall. See "Center Wall" earlier in this chapter.
7. Remove the system board and tray. See "System Board with Subpan" earlier in this
chapter.
Removal and Replacement Procedures 2-47
and the secondary power supply cable


1
from

2