Compaq DL580 - ProLiant - 1 GB RAM Maintenance And Service Manual page 82

Table 3-2
POST Error Messages
continued
Error Code Audible Beeps
1724-Slot x Drive None
Array – Physical
Drive Position
Change(s) Detected –
Logical drive
configuration has
automatically been
updated
1726-Slot x Drive None
Array – Array
Accelerator Memory
Size Change
Detected
1727-Slot x Drive None
Array – New Logical
Drive(s) Attachment
Detected. If more
than 32 logical
drives, this message
will be followed by:
Auto-configuration
failed: Too many
logical drives.
1730-Fixed Disk 0 None
does not support
DMA Mode.
1731-Fixed Disk 1 None
does not support
DMA Mode.
1740-Fixed Disk 0 None
failed Set Block
Mode command
1741-Fixed Disk 1 None
failed Set Block
Mode command
1750-Fixed Disk 0 None
failed Identify
command
1751-Fixed Disk 1 None
failed Identify
command
1760-Fixed Disk 0 None
does not support
Block Mode
Diagnostics and Troubleshooting 3-13
Probable Source of Problem
Logical drive configuration has
been updated automatically
following physical drive position
changes.
Indicates array accelerator
configuration has been updated
automatically due to replacement
of array accelerator (or controller)
with one having different
memory size.
Controller has detected an
additional array of drives that
were attached when the power
was off. The logical drive
configuration information has
been updated to add the new
logical drives. The maximum
number of logical drives
supported is 32. Additional
logical drives will not be added to
the configuration.
Hard drive error
Hard drive error
Hard drive error
Hard drive error
Hard drive error
Hard drive error
Hard drive error
Recommended Action
Press F1 to resume.
Press F1 to resume.
Press F1 to resume.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
Run the System Configuration
Utility and correct.
continued