Compaq DL580 - ProLiant - 1 GB RAM Maintenance And Service Manual page 81

3-12 Compaq ProLiant DL580 Server Maintenance and Service Guide
Table 3-2
POST Error Messages
Error Code
1622-Internal SCSI
Jumper Board Not
Installed
1703-SCSI cable
error detected.
Internal SCSI cable
not attached to
system board
connector. System
halted.
1703-SCSI Cable
Error Detected
Terminated cable
attached to output
connector of SCSI
backplane.
System Halted
1703-SCSI Cable
Error Detected
Must be configured
for Single backplane,
Simplex or Duplex
System Halted
1703-SCSI Cable
Error Detected
Simplex Mode
detected, but LED
cable not installed
System Halted
1720-Slot x Drive
Array – SMART Drive
Detects Imminent
Failure SCSI: Port y:
SCSI ID x
continued
Audible Beeps Probable Source of Problem
None The system has detected that the
array enabler board is not
installed.
None Incorrect cabling
None Terminated cable has
erroneously been attached to the
output connector of the SCSI
backplane.
None SCSI cables have been
connected in an unsupported
configuration.
None LED cable has failed or is not
connected properly.
None Indicated drive has reported a
SMART predictive-failure
condition and may fail at some
time in the future.
Recommended Action
Install the array enabler board.
Ensure that the integrated SCSI
controller has SCSI termination
attached.
Remove the terminated cable.
Reconnect the SCSI cables in a
supported configuration.
Reconnect or replace the LED
cable.
If drive is part of a
nonfault-tolerant configuration,
back up all data before
replacing drive and restore all
data afterward. If drive is part of
a fault-tolerant configuration
do not replace drive unless all
other drives in array are online.
Press F1 to resume.
continued