Compaq DL580 - ProLiant - 1 GB RAM Maintenance And Service Manual page 188

processor terminator module
part number 1-5
removing 2-27
removing, illustrated 2-27
replacing 2-27
processors
locations, identified 2-25
locations, illustrated 2-25
number unit can supported 2-25
part number 1-5
removing 2-26
removing, illustrated 2-26
replacing 2-26
slots, identified 4-3
test error codes 3-23
R
rack mounting kit, part number 1-7
rack warnings 2-6
Rapid Recovery Engine,
enabling 3-58
rapid recovery services 3-58
rear panel
components, illustrated 4-2
connectors, identified 4-2
NIC connectors, identified 4-2
peripheral board connectors,
identified 4-2
power supply connectors,
identified 4-2
recovery
attended 3-59
automatic 3-58, 3-59
environmental 3-59
rapid recovery services 3-58
software error 3-59
unattended 3-59
redundant controller
configuration 3-41, 3-50
redundant controllers installed are not
the same model 3-50
redundant ROM image
recovery 3-74
remote management features,
defined 3-72
remote service features,
defined 3-72
removable media assembly
drives supported 2-17
removing 2-17
removing, illustrated 2-17
replacing 2-17
removal and replacement procedures,
preparation 2-4
replacement battery See battery
reserve information sector See RIS
resource conflict, resolving 3-3
return kit, part number 1-7
Revision History Table
accessing 3-70
defined 3-70
where stored 3-70
RIS copies between drives do not
match 3-42
RJ-45 receptacle symbol 2-3
ROM
disaster recovery 3-73
flashing 3-73
ROMPaq
disaster recovery 3-73
Firmware Upgrade Utility,
accessing 3-5
recovery options 3-73
S
SCSI CD-ROM drives See
CD-ROM drive
SCSI hard drive backplane board
connectors, identified 4-6
connectors, illustrated 4-6
part number 1-6
power connector, identified 4-5
removing 2-34
removing, illustrated 2-34
replacing 2-34
SCSI hard drives See hard drives
SCSI port 1 connector,
identified 4-4
SCSI port X, Drive ID Y
failed – REPLACE (failure
message) 3-42
firmware needs upgrading 3-42
has exceeded threshold(s) 3-42
is not stamped for
monitoring 3-43
may have a loose
connection 3-43
RIS copies within this drive do
not match 3-43
S.M.A.R.T. predictive failure
errors have been detected in
the factory Monitor and
Performance data 3-43
was replaced on a good volume:
(failure message) 3-44
SCSI Port X, Drive ID Y
S.M.A.R.T. predictive failure
errors have been detected in
the since power Monitor and
Performance data 3-44
Index 13