Compaq DL580 - ProLiant - 1 GB RAM Maintenance And Service Manual page 79

3-10 Compaq ProLiant DL580 Server Maintenance and Service Guide
Table 3-2
POST Error Messages
Error Code
219-Snoop Rules
SRAM Failure.
System Halted.
220-Cache
Accelerator Slot x
Initialization Failed.
System Halted.
301-Keyboard Error
301-Keyboard Error
or Test Fixture
Installed
* ZZ-301-Keyboard
Error
303-Keyboard
Controller Error
304-Keyboard or
System Unit Error
40X-Parallel Port X
Address Assignment
Conflict
601-Diskette
Controller Error
605-Diskette Drive
Type Error
1151-Com Port 1
Address Assignment
Conflict
* ZZ represents the Keyboard Scan Code.
continued
Audible Beeps Probable Source of Problem
None Catastrophic chipset failure
None Cache accelerator in slot x
improperly installed or bad
None Keyboard failure
None Keyboard failure
None Keyboard failure
None System board, keyboard, or
mouse controller failure
None Keyboard, keyboard cable, or
system board failure
2 short Both external and internal ports
are assigned to parallel port X.
None Diskette controller circuitry
failure
2 short Mismatch in drive type
2 short Both external and internal serial
ports are assigned to COM1.
Recommended Action
Call Compaq authorized service
provider.
Check cache accelerator
installation and if properly
installed, replace.
Power down the computer, then
reconnect the keyboard.
Replace the keyboard.
1. A key is stuck. Try to
free it.
2. Replace the keyboard.
Run Diagnostics, then replace
failed assembly as indicated.
1. Make sure the keyboard is
attached.
2. Run Diagnostics to
determine whether the
keyboard, keyboard cable,
or system board is in error.
3. Replace the part indicated.
Run the System Configuration
Utility and correct.
1. Make sure the diskette
drive cables are attached.
2. Replace the diskette drive
and/or cable.
3. Replace the system board.
Run the System Configuration
Utility to set diskette type
correctly.
Run the System Configuration
Utility and correct.
continued