Compaq DL580 - ProLiant - 1 GB RAM Maintenance And Service Manual page 135

3-66 Compaq ProLiant DL580 Server Maintenance and Service Guide
Table 3-21
Compaq System Configuration Utility Pager Settings for Starting into Compaq Utilities
Pager Data
Network host
name
Network
Interface
Controller
(NIC) slot
Network frame
type
Network IP
address
Network IP net
mask
Network IP
router address
If you configure the server to restart, and then access the Compaq Utilities menu, it prepares for
remote communications. You can run Compaq Diagnostics, INSPECT, or the server-setup
utility remotely by using a workstation running terminal emulation software, such as Compaq
Insight Manager.
Initializing the Operating System
When you enable ASR-2 to restart into the operating system and a critical error occurs, ASR-2
logs the error into the Critical Error Log or IML, and restarts the server. The system ROM pages
the designated administrator, then executes the normal restart process.
IMPORTANT: When you enable ASR-2 to restart into the operating system, Modem Dial-In Status,
Network Status, and Modem Dial-Out Status are automatically disabled. In this mode, ASR-2 can page
you if a critical error occurs, but you cannot access the server, and the server cannot dial out to a remote
workstation.
If the ASR-2 feature cannot restart the server within 10 attempts, it logs a critical error into the
Critical Error Log or IML restarts the server into the Compaq Utilities, and puts the modem into
auto-answer mode.
Setting Description
CPQHOU Enter the network name of the server. Use underscores instead of
spaces within the name—for example, Compaq_Server. If you are using
IPX network access to the Compaq Utilities, this server name is used to
advertise NVT host services. This server name displays in the Compaq
Insight Manager server list when the program determines it can
communicate using NVT. Set this name to be the same as the server
name you assign when the host OS is running.
Slot # Select the slot number of the NIC you wish to use for network access to
Compaq Utilities.
ETHERNET_I I Select the frame type for the network. Selections include both Ethernet
and Token-Ring topologies.
Enter the IP address for this server in standard dot notation.
Note: This is not used if you select Custom for Network controller. You
must enter the IP address into the NET.CFG file that you load into the
system partition.
Enter the net mask for this server in standard dot notation.
Note: This is not used if you select Custom for network controller. You
must enter the IP address into the NET.CFG file that you load into the
system partition.
Enter the router to be used for this server in standard dot notation.
Note: This is not used if you select Custom for network controller. You
must enter the IP address into the NET.CFG file that you load into the
system partition.
continued