Compaq DL580 - ProLiant - 1 GB RAM Maintenance And Service Manual page 43

Processor Terminator Module
IMPORTANT: If a processor is removed, the processor terminator module must be reinstalled before
powering up the server. Failure to have either a processor or processor terminator module installed
results in an interlock fault condition that prevents the server from powering up.
To remove a processor terminator module:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the top access panel. See "Top Access Panel" earlier in this chapter.
3. Loosen the retention screw
4. Pull up the two ejector levers
connector slot.
5. Lift the processor terminator module
Figure 2-20. Removing a processor terminator module
Reverse steps 1 through 5 to replace a processor terminator module.
.


to release the processor terminator module from the

out of the slot.

2
1
3
Removal and Replacement Procedures 2-27
2