Compaq DL580 - ProLiant - 1 GB RAM Maintenance And Service Manual page 132

The following ASR-2 flowchart shows the sequence of events after a hardware or software
error occurs:
Unattended server starts the operating
If the server continues experiencing
hardware/software errors and the number
of ASR cycles exceeds the specified
number of recovery attempts, the server
logs an error to the Server Health Log or the
Integrated Management Log and starts the
Compaq Utilities from the system partition
on the hard drive.
Figure 3-1. ASR-2 flowchart
Hardware/Software error occurs.
Error is recorded in the Critical Error Log or
the Integrated Management Log, depending
on the server configuration.
Operating system halts normal operation.
ASR-2 timer expires.
Server is reset.
If a modem is installed and paging is
enabled, the Server Failure Notification
pager alert is sent to the Server
Administrator.
Or
system.
Diagnostics and Troubleshooting 3-63
Server starts Compaq Utilities from the
system partition on the hard drive.
If a modem is installed, ASR puts the
modem on auto-answer so that the server
administrator can dial in (using third-party
terminal emulator software) to remotely run
the Compaq Utilities to identify the source of
the fault.

Or

Local Server Administrator runs Compaq
Utilities from server console to identify the
source of the fault.