Compaq DL580 - ProLiant - 1 GB RAM Maintenance And Service Manual page 134

Table 3-21
Compaq System Configuration Utility Pager Settings for Starting into Compaq Utilities
Pager Data Setting
Pager test Select to test
pager setup
Serial interface COM1
Dial-In status Enabled
Dial-Out status Enabled
Dial-Out string 555-1234
Network status Enabled
Network
protocol
Network Compaq
controller
Description
Use this to test the current pager settings. Press Enter to dial the pager
number, and the pager message (if present) displays. You must
configure the computer before testing the pager, and the Pager Status
must be set to Enabled. Do not test the pager if you are running
remotely and are using only one modem.
Select the communications port for the modem used by the pager and
the remote ASR-2 functions. The options are COM1 and COM2.
Set Dial-In Status to Enabled. Be sure the Reset Boot option is set to
Boot Compaq Utilities. When the system starts because of an ASR-2
reset, it starts to the Compaq Utilities, sets the Management Modem to
auto-answer, and waits for the administrator to dial in and run the
Compaq Utilities.
You automatically disable this option when you configure the software
error recovery start option to Boot Operating System. When ASR-2 pages
you, you cannot dial in unless ASR-2 exceeds 10, the threshold number
of server restart retries. When this happens, ASR-2 restarts the server
into the Compaq Utilities and places the modem in auto-answer mode.
Allows ASR-2 to dial out to a remote workstation. If you selected this
option, Dial-In Status is automatically selected.
To use the Dial-Out feature, set Dial-Out Status to Enabled and set the
Dial-Out String to the correct telephone number. You must also set the
Reset Boot option to Boot Compaq Utilities. When the system restarts
because of an ASR-2 reset, the administrator is paged via Pager Status
and Pager Dial String, the system restarts to the Compaq Utilities, and
dials out to the phone number provided in the Dial-Out string. The
dial-out number is tried five times. If it fails to connect after five
attempts, the modem is put in auto-answer mode.
Enter the dial string followed by the remote computer telephone number.
To allow network access to Compaq Utilities, set Network Status to
Enabled and ensure that the Reset Boot option is set to Boot Compaq
Utilities.
To use IPX network access, set Network Protocol to IPX. When the
system restarts to the Compaq Utilities because of an ASR-2 reset, it
loads IPX network support. This enables remote access using NVT.
To use IP network access, set Network protocol to IP. Also make sure to
set Network IP address, Network IP net mask, and Network IP router
address. When the system restarts to the Compaq Utilities because of an
ASR-2 reset, it loads IP network support. This enables remote access
using Telnet.
Note: The Network Status must be set to Enabled for network access.
For all Compaq standard network controllers.
Diagnostics and Troubleshooting 3-65
continued
continued