2-8 Compaq ProLiant DL580 Server Maintenance and Service Guide
Top Access Panel
The ProLiant DL580 server ships standard in a rack-mount configuration. Remove the top
access panel to service the internal components.
To remove the top access panel:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Using a Torx T-15 screwdriver, loosen the three captive screws securing the top access
panel to the bezel.
3. Slide the top access panel back, then lift it from the chassis.
NOTE: The PCI Hot Plug access door allows access to the PCI Hot Plug area without removing the top
access panel.
Figure 2-1. Removing the top access panel
Reverse steps 1 through 3 to replace the top access panel.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal system
components to cool before removing them.