Pci Hot Plug Led Switchboard And Cable - Compaq DL580 - ProLiant - 1 GB RAM Maintenance And Service Manual

2-42 Compaq ProLiant DL580 Server Maintenance and Service Guide

PCI Hot Plug LED Switchboard and Cable

To remove the PCI Hot Plug LED switchboard and cable:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the top access panel. See "Top Access Panel" earlier in this chapter.
3. Remove all PCI Hot Plug expansion boards. See "PCI Expansion Boards" earlier in
this chapter.
4. Disconnect the PCI Hot Plug LED switchboard cable
5. Remove the three T-15 screws
the chassis.
6. Pull the PCI Hot Plug LED switchboard
the chassis.
Figure 2-33. Removing the PCI Hot Plug LED switchboard and cable
Reverse steps 1 through 6 to replace the PCI Hot Plug LED switchboard and cable.
that secure the PCI Hot Plug LED switchboard to

3
.


up, then lift the switchboard out from

2
2
1
2