Periodic Inventory Notification - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Periodic Inventory Notification

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 3
switch(config-callhome)# transport
email smtp-server 192.168.1.1
switch(config-callhome)# transport
email smtp-server 192.168.1.1 port 30
Periodic Inventory Notification
You can configure the switch to periodically send a message with an inventory of all the software
services currently enabled and running on the switch along with hardware inventory information. The
inventory is modified each time the switch is restarted nondisruptively.
By default, this feature is disabled in all switches in the Cisco MDS 9000 Family. When you enable this
feature without configuring an interval value, the Call Home message is sent every 7 days. This value
ranges from 1 to 30 days.
To enable periodic inventory notification in a Cisco MDS 9000 Family switch, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# callhome
switch(config-callhome)#
Step 3
switch(config-callhome)# periodic-inventory
notification
switch(config-callhome)# no
periodic-inventory notification
Step 4
switch(config-callhome)# periodic-inventory
notification interval 15
switch(config-callhome)# no
periodic-inventory notification interval 15
Cisco MDS 9000 Family CLI Configuration Guide
54-12
Purpose
Configures the DNS, IPv4 address, or IPv6 address of the
SMTP server to reach the server. The port usage defaults
to 25 if no port is specified.
The port number is optional and, if required, may
Note
be changed depending on the server location.
Purpose
Enters configuration mode.
Enters the Call Home configuration submode.
Enables the periodic inventory notification
feature. By default, the Call Home message is sent
every 7 days.
Disables the periodic inventory notification
feature (default).
Configures the periodic inventory notification
message to be sent every 15 days. This value
ranges from 1 to 30 days.
Defaults to using the factory default of sending a
Call Home message every 7 days.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 54 Configuring Call Home