Chapter 54
Configuring Call Home
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Fabric Lock Override
If you have performed a Call Home task and have forgotten to release the lock by either committing or
discarding the changes, an administrator can release the lock from any switch in the fabric. If the
administrator performs this task, your changes to the pending database are discarded and the fabric lock
is released.
The changes are only available in the volatile directory and are subject to being discarded if the switch
Tip
is restarted.
To use administrative privileges and release a locked Call Home session, use the clear callhome session
command.
switch# clear callhome session
Database Merge Guidelines
See the
When merging two Call Home databases, follow these guidelines:
•
•
Call Home Communications Test
Use the test command to simulate a message generation.
To test the Call Home function, follow these steps:
Command
Step 1
switch# callhome test
trying to send test callhome message
successfully sent test callhome message
Step 2
switch# callhome test inventory
trying to send test callhome message
successfully sent test callhome message
OL-16184-01, Cisco MDS SAN-OS Release 3.x
"CFS Merge Support" section on page 6-8
Be aware that the merged database contains the following information:
A superset of all the destination profiles from the dominant and subordinate switches take part
–
in the merge protocol.
The e-mail addresses and alert groups for the destination profiles.
–
Other configuration information (for example, message throttling, periodic inventory) from the
–
switch that existed in the dominant switch before the merge.
Verify that two destination profiles do not have the same name (even if they have different
configuration information) on the subordinate and dominant switches. If they do contain the same
name, the merge operation will fail. You must then modify or delete the conflicting destination
profile on the required switch.
Call Home Communications Test
for detailed concepts.
Purpose
Sends a test message to the configured destination(s).
Sends a test inventory message to the configured
destination(s).
Cisco MDS 9000 Family CLI Configuration Guide
54-15