Configuring Obfl For A Module - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

On-Board Failure Logging
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 2
switch(config)# hw-module logging onboard
switch(config)# hw-module logging onboard cpu-hog
switch(config)# hw-module logging onboard
environmental-history
switch(config)# hw-module logging onboard
error-stats
switch(config)# hw-module logging onboard
interrupt-stats
switch(config)# hw-module logging onboard mem-leak
switch(config)# hw-module logging onboard
miscellaneous-error
switch(config)# hw-module logging onboard obfl-log
switch(config)# no hw-module logging onboard
Use the show logging onboard status command to display the configuration status of OBFL.
switch# show logging onboard status

Configuring OBFL for a Module

To configure OBFL for specific modules on the switch, follow these steps
Command
Step 1
switch# config terminal
switch(config)#
Cisco MDS 9000 Family CLI Configuration Guide
59-24
Switch OBFL Log:
Module: 6 OBFL Log:
error-stats
exception-log
miscellaneous-error
obfl-log (boot-uptime/device-version/obfl-history)
system-health
stack-trace
Chapter 59 Monitoring System Processes and Logs
Purpose
Enables all OBFL features.
Enables the OBFL CPU hog events.
Enables the OBFL environmental history.
Enables the OBFL error statistics.
Enables the OBFL interrupt statistics.
Enables the OBFL memory leak events.
Enables the OBFL miscellaneous
information.
Enables the boot uptime, device version,
and OBFL history.
Disables all OBFL features.
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Purpose
Enters configuration mode.
OL-16184-01, Cisco MDS SAN-OS Release 3.x