How to Configure Call Home
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Router# configure terminal
Step 2
service call-home
Example:
Router(config)# service call-home
Step 3
no service call-home
Example:
Router(config)# no service call-home
Sending Call Home Communications Manually
You can manually send several types of Call Home communications. To send Call Home
communications, complete the tasks in this section. This section contains the following subsections:
•
•
•
•
Sending a Call Home Test Message Manually
You can use the call-home test command to send a user-defined Call Home test message.
SUMMARY STEPS
1.
DETAILED STEPS
Command or Action
Step 1
call-home test ["test-message"] profile name
Example:
Router# call-home test profile profile1
Sending Call Home Alert Group Messages Manually
You can use the call-home send command to manually send a specific alert group message.
Note the following guidelines when manually sending a Call Home alert group message:
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
24
Sending a Call Home Test Message Manually, page 24
Sending Call Home Alert Group Messages Manually, page 24
Submitting Call Home Analysis and Report Requests, page 25
Sending the Output of a Command to Cisco or an E-Mail Address, page
call-home test ["test-message"] profile name
Purpose
Enters global configuration mode.
Enables the Call Home feature.
Disables the Call Home feature.
Purpose
Sends a test message to the specified destination profile.
The user-defined test message text is optional, but must be
enclosed in quotes (" ") if it contains spaces. If no
user-defined message is configured, a default message is
sent.
Configuring Call Home
27t