Cisco ASR1002 - ASR 1002 Router Software Configuration Manual page 390

Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking
Command or Action
Step 11
clock source internal
Example:
Router(config-controller)# clock source internal
Step 12
linecode b8zs
Example:
Router(config-controller)# linecode b8zs
Step 13
cablelength long db-loss-value
Example:
Router(config-controller)# cablelength long 0db
Step 14
channel-group channel-group-number timeslots range
Example:
Router(config-controller)# channel-group 0 timeslots
1-24
Step 15
exit
Step 16
pseudowire-class [pw-class-name]
Example:
Router(config)# pseudowire-class atm-fr-bridged
Step 17
encapsulation mpls
Example:
Router(config-pw-class)# encapsulation mpls
Step 18
interworking ethernet
Example:
Router(config-pw-class)# interworking ethernet
Step 19
exit
Step 20
interface loopback loopback-interface-number
Example:
Router(config)# interface loopback 0
Step 21
ip address ip-address mask
Example:
Router(config-if)# ip address 44.1.1.2
255.255.255.255
Step 22
exit
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
14
Purpose
Configures the clock source of a DS1 link and uses
the internal clock from the interface.
Specifies Binary 8-Zero Substitution (B8ZS) as the
line code type for the T1 controller.
Decreases the transmit signal by 0 dB. This is the
default value.
Configures serial WAN on a T1 or E1 interface.
Exits the pseudowire class configuration mode.
Establishes a pseudowire class with a name that you
specify and enters the pseudowire class
configuration mode.
Enables MPLS encapsulation on the interface.
Enables the L2VPN Ethernet interworking feature.
Exits the pseudowire class configuration mode.
Specifies the Loopback logical interface.
Specifies the IP address for the Loopback interface.
Exits the interface configuration mode.
Configuring MPLS Layer 2 VPNs