Cisco ASR1002 - ASR 1002 Router Software Configuration Manual page 188

Software Upgrade Process
Upgrade Process With Service Impact for Nonredundant Platforms
Proceed with switchover to standby RP? [confirm]
%ASR1000_INFRA-6-CONSOLE_ACTIVE: R0/1 console active. Press RETURN to get started!
*Sep 25 18:08:27.898: %CMANRP-6-CMHASTATUS: RP switchover, received fastpath becoming
active event
*Sep 25 18:08:28.224: %CMANRP-6-CMHASTATUS: RP switchover, received chassis event to
become active
*Sep 25 18:08:28.229: %NETCLK-5-NETCLK_MODE_CHANGE: Network clock source not available.
The network clock has changed to freerun
*Sep 25 18:08:28.243: %REDUNDANCY-3-SWITCHOVER: RP switchover (PEER_NOT_PRESENT)
*Sep 25 18:08:28.243: %REDUNDANCY-3-SWITCHOVER: RP switchover (PEER_DOWN)
*Sep 25 18:08:28.243
Manual Swact = enabled
*Sep 25 18:08:27.956: %SYS-5-SWITCHOVER: Switchover requested by Exec. Reason: redundancy
force-switchover.: %REDUNDANCY-3-SWITCHOVER: RP switchover (PEER_REDUNDANCY_STATE_CHANGE)
*Sep 25 18:08:28.248: %PLATFORM-6-HASTATUS: RP switchover, sent message became active. IOS
is ready to switch to primary after chassis confirmation
*Sep 25 18:08:28.249: %CMANRP-6-CMHASTATUS: RP switchover, received chassis event became
active
*Sep 25 18:08:28.497: %PLATFORM-6-HASTATUS_DETAIL: RP switchover, received chassis event
became active. Switch to primary (count 1)
*Sep 25 18:08:29.746: %ACE-3-TRANSERR: ASR1000-ESP(14): IKEA trans 0x3; opcode 0x25; param
0xA; error 0x4; retry cnt 0
*Sep 25 18:08:29.746: %ACE-3-TRANSERR: ASR1000-ESP(14): IKEA trans 0x4; opcode 0x25; param
0xB; error 0x4; retry cnt 0
*Sep 25 18:08:29.746: %ACE-3-TRANSERR: ASR1000-ESP(14): IKEA trans 0x5; opcode 0x25; param
0xC; error 0x4; retry cnt 0
*Sep 25 18:08:30.630: %LINK-3-UPDOWN: Interface Null0, changed state to up
*Sep 25 18:08:30.631: %LINK-3-UPDOWN: Interface Loopback0, changed state to up
*Sep 25 18:08:30.635: %LINK-5-CHANGED: Interface POS0/0/0, changed state to
administratively down
*Sep 25 18:08:30.636: %LINK-5-CHANGED: Interface POS0/1/0, changed state to
administratively down
*Sep 25 18:08:30.636: %LINK-5-CHANGED: Interface POS0/1/1, changed state to
administratively down
*Sep 25 18:08:30.636: %LINK-5-CHANGED: Interface GigabitEthernet0/3/0, changed state to
administratively down
*Sep 25 18:08:30.636: %LINK-5-CHANGED: Interface GigabitEthernet0/3/1, changed state to
administratively down
*Sep 25 18:08:30.636: %LINK-5-CHANGED: Interface GigabitEthernet0/3/2, changed state to
administratively down
*Sep 25 18:08:30.636: %LINK-5-CHANGED: Interface GigabitEthernet0/3/3, changed state to
administratively down
*Sep 25 18:08:30.636: %LINK-5-CHANGED: Interface GigabitEthernet0/3/4, changed state to
administratively down
*Sep 25 18:08:31.630: %LINEPROTO-5-UPDOWN: Line protocol on Interface Null0, changed state
to up
*Sep 25 18:08:31.630: %LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback0, changed
state to up
*Sep 25 18:09:16.667: %REDUNDANCY-3-IPC: IOS versions do not match.
*Sep 25 18:09:16.717: %REDUNDANCY-5-PEER_MONITOR_EVENT: Active detected a standby
insertion (raw-event=PEER_FOUND(4))
*Sep 25 18:09:16.717: %REDUNDANCY-5-PEER_MONITOR_EVENT: Active detected a standby
insertion (raw-event=PEER_REDUNDANCY_STATE_CHANGE(5))
*Sep 25 18:11:00.500: %HA_CONFIG_SYNC-6-BULK_CFGSYNC_SUCCEED: Bulk Sync succeeded
*Sep 25 18:11:00.502: %RF-5-RF_TERMINAL_STATE: Terminal state reached for (SSO)
Router# show platform
Chassis type: ASR1004
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
106