Cisco ASR1002 - ASR 1002 Router Software Configuration Manual page 213

Software Upgrade Process
*Sep 25 11:31:33.438: %REDUNDANCY-3-SWITCHOVER: RP switchover
(PEER_REDUNDANCY_STATE_CHANGE)
*Sep 25 11:31:33.442: %PLATFORM-6-HASTATUS: RP switchover, sent message became active. IOS
is ready to switch to primary after
Manual Swact = enabled
*Sep 25 11:31:33.061: %SYS-5-SWITCHOVER: Switchover requested by Exec. Reason: redundancy
force-switchover. chassis confirmation
*Sep 25 11:31:33.446: %CMANRP-6-CMHASTATUS: RP switchover, received chassis event became
active
*Sep 25 11:31:33.692: %PLATFORM-6-HASTATUS_DETAIL: RP switchover, received chassis event
became active. Switch to primary (count 1)
*Sep 25 11:31:35.683: %ACE-3-TRANSERR: ASR1000-ESP(14): IKEA trans 0x3; opcode 0x25; param
0xA; error 0x4; retry cnt 0
*Sep 25 11:31:35.683: %ACE-3-TRANSERR: ASR1000-ESP(14): IKEA trans 0x4; opcode 0x25; param
0xB; error 0x4; retry cnt 0
*Sep 25 11:31:35.684: %ACE-3-TRANSERR: ASR1000-ESP(14): IKEA trans 0x5; opcode 0x25; param
0xC; error 0x4; retry cnt 0
*Sep 25 11:31:35.802: %LINK-3-UPDOWN: Interface Null0, changed state to up
*Sep 25 11:31:35.803: %LINK-3-UPDOWN: Interface Loopback0, changed state to up
*Sep 25 11:31:35.808: %LINK-5-CHANGED: Interface POS0/0/0, changed state to
administratively down
*Sep 25 11:31:35.808: %LINK-5-CHANGED: Interface POS0/1/0, changed state to
administratively down
*Sep 25 11:31:35.808: %LINK-5-CHANGED: Interface POS0/1/1, changed state to
administratively down
*Sep 25 11:31:35.808: %LINK-5-CHANGED: Interface GigabitEthernet0/3/0, changed state to
administratively down
*Sep 25 11:31:35.808: %LINK-5-CHANGED: Interface GigabitEthernet0/3/1, changed state to
administratively down
*Sep 25 11:31:35.808: %LINK-5-CHANGED: Interface GigabitEthernet0/3/2, changed state to
administratively down
*Sep 25 11:31:35.808: %LINK-5-CHANGED: Interface GigabitEthernet0/3/3, changed state to
administratively down
*Sep 25 11:31:35.808: %LINK-5-CHANGED: Interface GigabitEthernet0/3/4, changed state to
administratively down
*Sep 25 11:31:36.802: %LINEPROTO-5-UPDOWN: Line protocol on Interface Null0, changed state
to up
*Sep 25 11:31:36.802: %LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback0, changed
state to up
*Sep 25 11:32:21.530: %REDUNDANCY-3-IPC: IOS versions do not match.
*Sep 25 11:32:21.615: %REDUNDANCY-5-PEER_MONITOR_EVENT: Active detected a standby
insertion (raw-event=PEER_FOUND(4))
*Sep 25 11:32:21.615: %REDUNDANCY-5-PEER_MONITOR_EVENT: Active detected a standby
insertion (raw-event=PEER_REDUNDANCY_STATE_CHANGE(5))
*Sep 25 11:34:05.450: %HA_CONFIG_SYNC-6-BULK_CFGSYNC_SUCCEED: Bulk Sync succeeded
*Sep 25 11:34:05.453: %RF-5-RF_TERMINAL_STATE: Terminal state reached for (SSO)
Router# show platform
Chassis type: ASR1004
Slot
--------- ------------------- --------------------- -----------------
0
0/0
0/1
0/3
R0
R0/0
R0/1
F0
Type State
ASR1000-SIP10 ok
SPA-1XOC12-POS ok
SPA-2XOC3-POS ok
SPA-5X1GE-V2 ok
ASR1000-RP1 ok
ok, standby
ok, active
ASR1000-ESP10 ok, active
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Upgrade Process With Service Impact for Nonredundant Platforms
Insert time (ago)
00:31:12
00:11:35
00:11:35
00:11:35
00:31:12
00:05:38
00:13:36
00:31:12
131