Issu Rollback Timer Overview; Software Upgrade With Dual Ios Processes On A Single Rp Overview; Cisco Ios Xe Software Package Compatibility For Issu - Cisco ASR1002 - ASR 1002 Router Software Configuration Manual

ISSU Upgrade for Redundant Platforms

ISSU Rollback Timer Overview

The Cisco ASR 1000 Series Router ISSU procedure has a rollback timer. Rollback timers are used for
for ISSU procedures on all Cisco routers that support ISSU, but this section will provide a brief overview
of ISSU rollback timers on the Cisco ASR 1000 Series Routers.
During ISSU, the rollback timer begins after the consolidated package or subpackage is loaded. If the
upgrade does not move forward in the amount of time specified in the rollback timer, the configuration
will automatically "roll back" to the previous configuration and the ISSU upgrade will be cancelled.
Upgrades using the issu command set and the request platform command set both have the rollback
timer option. The issu command set always uses a rollback timer; the request platform command set
does not use a rollback timer unless the auto-rollback option is used in the request platform software
package install command line.
For the issu command set, the issu acceptversion command can be entered to stop the rollback timer
without committing the upgrade during the ISSU upgrade. The issu commitversion command can be
entered to stop the rollback timer and commit the ISSU upgrade.
For the request platform command set, the request platform software package install rp slot commit
command must be entered to stop the rollback timer only in cases where the auto-rollback option is
used.
The rollback timer for the issu command set can be configured by entering the issu set rollback-timer
command. The rollback timer when used with the request platform command set is specified when you
use the auto-rollback option when entering the issu request platform software package install
command.
For ISSU upgrades on Cisco ASR 1000 Series Routers, it may be advisable to set long rollback times
when the upgrade is being performed on routers with large configurations.
The amount of time left on the rollback timer during an ISSU upgrade can be checked by entering the
show issu rollback-timer command.

Software Upgrade with Dual IOS Processes on a Single RP Overview

To complete a software upgrade of an individual subpackage using dual IOS processes on a single RP,
SSO must first be enabled.
Software upgrade with dual IOS processes is useful for upgrading the individual RP subpackages that
can be upgraded without a router reload. See
that most subpackage upgrades in a single RP configuration require a hardware reload to complete
(whether an RP reload for an RP subpackage, an ESP reload for the ESPBase subpackage, a SIP reload
for a SIPBase subpackage, or a SPA reload for the SIPSPA subpackage), so limited interruption upgrades
for single RP configurations are not available in most upgrade scenarios.
For information on configuring a second IOS process on a single RP, see the
Software Upgrade on a Cisco ASR 1002 or Cisco ASR 1004 Router (software upgrade Command Set)"
section on page

Cisco IOS XE Software Package Compatibility for ISSU

When upgrading the Cisco IOS XE operating system software using the ISSU process, it is important to
determine the compatibility of the upgraded software to your current software and hardware. The ISSU
process allows software to be updated or otherwise modified while packet forwarding continues with
minimal interruption.
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
4
94.
Table 11 for a list of these subpackages. Importantly, note
Software Upgrade Process
"Using SubPackages for