Cisco ASR1002 - ASR 1002 Router Software Configuration Manual page 391

Configuring MPLS Layer 2 VPNs
Command or Action
Step 23
interface serial slot/subslot/port:timeslot
Example:
Router(config)# interface Serial0/3/0:0
Step 24
no ip address
Example:
Router(config-if)# no ip address
Step 25
encapsulation frame-relay
Example:
Router(config-if)# encapsulation frame-relay
Step 26
frame-relay intf-type dce
Example:
Router(config-if)# frame-relay intf-type dce
Step 27
frame-relay interface-dlci dlci switched
Example:
Router(config-if)# frame-relay interface-dlci 101
switched
Step 28
exit
Step 29
interface GigabitEthernet slot/subslot/port
Example:
Router(config)# interface GigabitEthernet 0/0/1
Step 30
ip address ip-address mask
Example:
Router(config-if)# ip address 10.10.1.2
255.255.255.0
Step 31
negotiation auto
Example:
Router(config-if)# negotiation auto
Step 32
mpls ip
Example:
Router(config-if)# mpls ip
Step 33
exit
Configuring Frame Relay DLCI-to-ATM AAL5SNAP Bridged Interworking
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Purpose
Specifies a serial interface created on a channelized
T1 controller.
Removes the previously configured IP address.
Configures the Cisco Frame Relay encapsulation on
serial interface.
Configures a Frame Relay switch type. The router
functions as a switch connected to a router.
Assigns a data-link connection identifier (DLCI) to
a specified Frame Relay subinterface on the router.
Exits the interface configuration mode.
Specifies the Gigabit Ethernet interface for the
connection of the PE routers.
Specifies the IP address for the Gigabit Ethernet
interface.
Enables the auto negotiation protocol to configure
the speed, duplex, and automatic flow control of the
Gigabit Ethernet interface.
Enables MPLS forwarding of the IPv4 packets
towards the MPLS core.
Exits the interface configuration mode.
15