Cisco ASR1002 - ASR 1002 Router Software Configuration Manual page 40

Getting Help
Table 9 Finding Command Options (continued)
Command
Router(config-if)# ?
Interface configuration commands:
.
.
.
ip Interface Internet Protocol config
commands
keepalive Enable keepalive
lan-name LAN Name command
llc2 LLC2 Interface Subcommands
load-interval Specify interval for load calculation
for an
interface
locaddr-priority Assign a priority group
logging Configure logging for interface
loopback Configure internal loopback on an
interface
mac-address Manually set interface MAC address
mls mls router sub/interface commands
mpoa MPOA interface configuration commands
mtu Set the interface Maximum Transmission
Unit (MTU)
netbios Use a defined NETBIOS access list or
enable
name-caching
no Negate a command or set its defaults
nrzi-encoding Enable use of NRZI encoding
ntp Configure NTP
.
.
.
Router(config-if)#
Router(config-if)# ip ?
Interface IP configuration subcommands:
access-group Specify access control for packets
accounting Enable IP accounting on this interface
address Set the IP address of an interface
authentication authentication subcommands
bandwidth-percent Set EIGRP bandwidth limit
broadcast-address Set the broadcast address of an
interface
cgmp Enable/disable CGMP
directed-broadcast Enable forwarding of directed
broadcasts
dvmrp DVMRP interface commands
hello-interval Configures IP-EIGRP hello interval
helper-address Specify a destination address for UDP
broadcasts
hold-time Configures IP-EIGRP hold time
.
.
.
Router(config-if)# ip
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
10
Comment
Enter ? to display a list of all the interface
configuration commands available for the serial
interface. This example shows only some of the
available interface configuration commands.
Enter the command that you want to configure for
the interface. This example uses the ip command.
Enter ? to display what you must enter next on the
command line. This example shows only some of
the available interface IP configuration commands.
Using Cisco IOS XE Software