Traceroute - NETGEAR FS728TPv2 Software Administration Manual

FS728TP Smart Switch Software Administration Manual
If successful, you will see "Reply From IP/Host: icmp_seq = 0. time = xx usec. Tx = x,
•
Rx = x Min/Max/Avg RTT = x/x/x msec."
If a reply to the ping is not received, you will see "Reply From IP/Host: Destination
•
Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec".

Traceroute

Use the Traceroute utility to discover the paths that a packet takes to a remote destination.
To display this page, click Maintenance  Troubleshooting  Traceroute.
To configure the Traceroute settings and send probe packets to discover the route to a host
on the network:
In the Hostname/IP Address field, specify the IP address or the hostname of the
1.
station you want the switch to ping. The initial value is blank. This information is not
retained across a power cycle.
Optionally, configure the following settings:
2.
Probes Per Hop. Specify the number of times each hop should be probed. The valid
•
range is 1–10.
MaxTTL. Specify the maximum time-to-live for a packet in number of hops. The valid
•
range is 1–255.
InitTTL. Specify the initial time-to-live for a packet in number of hops. The valid range
•
is 0– 255.
MaxFail. Specify the maximum number of failures allowed in the session. The valid
•
range is 0–255.
Interval. Specify the time between probes in seconds. The valid range is 1–60.
•
Chapter 7: Maintenance | 227