NETGEAR FS728TPv2 Software Administration Manual page 92

To configure STP settings on the switch:
From the Spanning Tree State field, specify whether to enable or disable Spanning
1.
Tree operation on the switch.
From the STP Operation Mode field, Specifies the Force Protocol Version parameter for the
2.
switch. Options are:
STP (Spanning Tree Protocol): IEEE 802.1D
•
RSTP (Rapid Spanning Tree Protocol): IEEE 802.1w
•
MSTP (Multiple Spanning Tree Protocol): IEEE 802.1s
•
Specify the configuration name and revision level.
3.
Configuration Name. Name used to identify the configuration currently being used. It
•
may be up to 32 alphanumeric characters.
Configuration Revision Level. Number used to identify the configuration currently
•
being used. The values allowed are between 0 and 65535. The default value is 0.
Specify the BPDU Flooding status for all ports or for individual ports. When this feature is
4.
enabled, BPDU packets arriving at this port are flooded to other ports if STP is disabled.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
5.
the latest value of the switch
If you make any configuration changes, click Apply to send the updated configuration to the
6.
switch. Configuration changes occur immediately.
92 | Chapter 3: Configuring Switching Information
FS728TP Smart Switch Software Administration Manual