Ip Configuration - NETGEAR FS728TPv2 Software Administration Manual

FS728TP Smart Switch Software Administration Manual
To define system information:
Open the System Information page.
1.
Define the following fields:
2.
System Name. Enter the name you want to use to identify this switch. You may use
•
up to 31 alphanumeric characters. The factory default is blank.
System Location. Enter the location of this switch. You may use up to 31
•
alphanumeric characters. The factory default is blank.
System Contact. Enter the contact person for this switch. You may use up to 31
•
alphanumeric characters. The factory default is blank.
Click Apply.
3.
The system parameters are applied, and the device is updated.
The following table describes the status information the System Page displays.
Field
Serial Number
System Object ID
Date & Time
System Up Time
Base MAC Address
Model Name
Boot Version
Software Version

IP Configuration

Use the IP Configuration page to configure network information for the management
interface, which is the logical interface used for in-band connectivity with the switch through
any of the switch's front panel ports. The configuration parameters associated with the
switch's network interface do not affect the configuration of the front panel ports through
which traffic is switched or routed.
To access the page, click System  Management  IP Configuration. A screen similar to the
following displays.
Description
The serial number of the switch.
The base object ID for the switch's enterprise MIB.
The current date and time.
Displays the number of days, hours, and minutes since the last system
restart.
The universally assigned network address.
The model name of the switch.
The boot code version of the switch.
The software version of the switch.
Chapter 2: Configuring System Information | 33