Understanding The User Interfaces; Using The Web Interface - NETGEAR FS728TPv2 Software Administration Manual

FS728TP Smart Switch Software Administration Manual

Understanding the User Interfaces

The FS728TP Smart Switch software includes a set of comprehensive management
functions for configuring and monitoring the system by using one of the following methods:
Web user interface
•
Simple Network Management Protocol (SNMP)
•
Each of the standards-based management methods allows you to configure and monitor the
components of the FS728TP Smart Switch software. The method you use to manage the
system depends on your network size and requirements, and on your preference.
The FS728TP Smart Switch Software Administration Manual describes how to use the
Web-based interface to manage and monitor the system.

Using the Web Interface

To access the switch by using a Web browser, the browser must meet the following software
requirements:
HTML version 4.0, or later
•
HTTP version 1.1, or later
•
Java Runtime Environment 1.6 or later
•
Use the following procedures to log on to the Web interface:
Open a Web browser and enter the IP address of the switch in the Web browser
1.
address field.
The factory default password is password. Type the password into the field on the login
2.
screen, as shown in
sensitive.
After the system authenticates you, the System Information page displays.
3.
Figure 3 on page 26 shows the layout of the Smart Switch Web interface.
Figure 2 on page 18, and then click Login. Passwords are case
Chapter 1: Getting Started | 25