NETGEAR FS728TPv2 Software Administration Manual page 56

To access the Trap Flags page, click System  SNMP  SNMP V1/V2  Trap Flags.
To configure the trap flags:
From the Authentication field, enable or disable activation of authentication failure
1.
traps by selecting the corresponding button. The factory default is Enable.
From the Link Up/Down field, enable or disable activation of link status traps by selecting
2.
the corresponding button. The factory default is Enable.
From the Spanning Tree field, enable or disable activation of spanning tree traps by
3.
selecting the corresponding button. The factory default is Enable.
If you make any changes to this page, click Apply to send the updated configuration to the
4.
switch. Configuration changes take effect immediately.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
5.
the latest value of the switch.
56 | Chapter 2: Configuring System Information
FS728TP Smart Switch Software Administration Manual