FS728TP Smart Switch Software Administration Manual
WARNING!
When you change the IP address of your administrative system,
you will loose your connection to the rest of the network. Be sure
to write down your current network address settings before you
change them.
To modify the network settings on your administrative system:
On your PC, access the MS Windows operating system TCP/IP Properties.
1.
Set the IP address of the administrative system to an address in the 192.168.0.0 network,
2.
such as 192.168.0.200. The IP address must be different from that of the switch but within
the same subnet.
Click OK.
3.
To configure a static address on the switch:
Use a straight-through cable to connect the Ethernet port on the administrative system
1.
directly to any port on the FS728TP.
Open a Web browser on your PC and connect to the management interface as described in
2.
on page 18.
Web Access
Change the network settings on the switch to match those of your network (this procedure is
3.
described in
IP Configuration
After you change the network settings on the switch, return the network configuration on your
administrative system to the original settings.
on page 33).
Chapter 1: Getting Started
| 17