Static Mac Address - NETGEAR FS728TPv2 Software Administration Manual

To configure the Dynamic Address setting:
Specify the number of seconds the forwarding database should wait before deleting a
1.
learned entry that has not been updated. IEEE 802.1D-1990 recommends a default of
300 seconds. You may enter any number of seconds between 10 and 1000000. The
factory default is 300.
IEEE 802.1D recommends a default of 300 seconds, which is the
Note:
factory default.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
2.
the latest value of the switch.
Click Apply to apply to send the updated configuration to the switch. Configuration changes
3.
take effect immediately.

Static MAC Address

Use the Static MAC Address Configuration page to configure and view static MAC addresses
on an interface.
To access the Static MAC Address Configuration page, click Switching Address Table 
Advanced  Static MAC Address.
118 | Chapter 3: Configuring Switching Information
FS728TP Smart Switch Software Administration Manual