Cos Interface Configuration - NETGEAR FS728TPv2 Software Administration Manual

FS728TP Smart Switch Software Administration Manual
To configure global CoS settings:
Select the Global radio button to configure the trust mode settings that apply to all
1.
interfaces.
Alternatively, you can select the Interface radio button to apply trust mode settings to
individual interfaces. The per-interface setting overrides the global settings.
Select the trust mode for all interfaces (Global Trust Mode) or the selected interface
2.
(Interface Trust Mode). This setting determines the type of CoS marking to trust when the
frame enters the port.
Untrusted. Do not trust any CoS packet marking at ingress.
•
802.1p. The switch supports eight hardware priority queues. For information about
•
mapping IEEE 802.1p priorities to the switch hardware priority queues, see
Queue Mapping
DSCP. The six most significant bits of the DiffServ field are called the Differentiated
•
Services Code Point (DSCP) bits. For information about mapping DSCP values to the
switch hardware priority queues, see
•
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
3.
the latest value of the switch.
If you change any of the settings on the page, click Apply to send the updated configuration
4.
to the switch.

CoS Interface Configuration

Use the CoS Interface Configuration page to apply an interface shaping rate to all interfaces
or to a specific interface.
To display the CoS Interface Configuration page, click the QoS  CoS tab, and then click the
Advanced  CoS Interface Configuration link.
on page 126.
DSCP to Queue Mapping
Chapter 4: Configuring Quality of Service
802.1p to
on page 127.
| 123