NETGEAR FS728TPv2 Software Administration Manual page 246

Click Apply.
4.
From the Policy Configuration screen, create a new policy with the following settings:
5.
Policy Selector: Policy1
•
Member Class: Class1
•
For more information about this screen, see
Click Add to add the new policy.
6.
Click the Policy1 hyperlink to view the Policy Class Configuration screen for this policy.
7.
Configure the Policy attributes as follows:
8.
Assign Queue: 3
•
Policy Attribute: Simple Policy
•
Color Mode: Color Blind
•
Committed Rate: 1000000 Kbps
•
Committed Burst Size: 128 KB
•
Confirm Action: Send
•
Violate Action: Drop
•
For more information about this screen, see
From the Service Configuration screen, select the check box next to interfaces g7 and g8 to
9.
attach the policy to these interfaces, and then click Apply (See
page 137).
All UDP packet flows destined to the 192.12.2.0 network with an IP source address from the
192.12.1.0 network that have a Layer 4 Source port of 4567 and Destination port of 4568
from this switch on ports 7 and 8 are assigned to hardware queue 3.
On this network, traffic from streaming applications uses UDP port 4567 as the source and
4568 as the destination. This real-time traffic is time sensitive, so it is assigned to a
high-priority hardware queue. By default, data traffic uses hardware queue 0, which is
designated as a best-effort queue.
Also the confirmed action on this flow is to send the packets with a committed rate of
1000000 Kbps and burst size of 128 KB. Packets that violate the committed rate and burst
size are dropped.
246 | Appendix B: Configuration Examples
FS728TP Smart Switch Software Administration Manual
Policy Configuration
Policy Configuration
on page 134.
on page 134.
Service Configuration
on