Hp Netserver Lxr Pro - HP LC2000r - NetServer - 128 MB RAM Configuration Manual

Introduction
This document defines the supported HP NetServer LXr Pro configurations for Microsoft Cluster Server.
These configurations minimize single points of failure, provide maximum availability, and have been
certified by Hewlett-Packard and Microsoft. This guide is prescriptive; it describes the HP NetServer LXr
Pro configurations supported by HP. Any configuration not expressly allowed by this guide will not be
supported by HP.
What's Defined in a Racked Cluster
Cluster
Type of SPUs
Number of nodes
Shared Storage
LANs:
Client LAN
Intra-cluster
(Heartbeat) LAN
Power source

HP NetServer LXr Pro

with
NetRAID (HP Rack Storage/8)
Cluster Configuration Guide
18 November 1998
Cluster
SPUs
Local and Shared Storage
Intra-cluster and Client LANs
Shared Storage Cabling
HP NetServer LXr Pro Model 1
Each node must be the same model SPU, but may have different size main
memory, cache, and number of CPUs (at least 2 are required).
2
HP Rack Storage/8 with HP NetRAID controller and HP disks. See
Shared Storage below.
Any NIC that is HP and Microsoft approved. See
HP D5013A or J3171A only with crossover cable. See
below.
Direct from power mains, power conditioner or uninterruptible power
supply (UPS) using any power conditioner or UPS.
Client LAN below.
Intra-cluster LAN