HP LC2000r - NetServer - 128 MB RAM Configuration Manual page 17

3. Install the following types of components as provided using the instructions with each component. If
necessary refer to HP Information Assistant for additional instructions:
Processors. Standard HP NetServer LXr Pros are equipped with either one or two Pentium Pro 200
MHz main processors. To operate a Microsoft Server Cluster, both HP NetServers must be equipped
with dual Pentium Pro processors.
Main Memory. Single-processor HP NetServer LXr Pros are shipped from the factory with 128
MB of main memory. Dual processor LXr Pros are shipped with 512 MB of main memory. Cluster
operations require a minimum of 128 MB of main memory. Typically you do not need to add
memory to your LXr Pros. However, if additional memory was provided install the additional
memory.
LAN Adapters. Install two LAN adapters in each system. If other cards are in the PCI slots listed
below, remove them and install them in another slot. LAN adapter must be installed in PCI slots as
follows:
PCI slot P1 (Client LAN)
PCI slot P2 (Intra-cluster LAN)
Internal Disks. If provided install the local storage drives (internal drives) into the LXr Pros using
kit D5962A.
NetRAID Adapters. Some cluster configurations use two NetRAID adapters for management of
shared storage. Typically, only one is provided (installed) in the HP NetServers. Therefore, if
provided install the second NetRAID adapter in each server using PCI slots P4-P6.
NOTE
NetRAID Adapters must be installed in PCI slots P4-P6. If the factory installed adapter
is installed in a slot other then P4-P6 remove it and reinstall the adapter.
4. Replace the HP NetServer LXr Pro's cover and secure thumbscrews.
5. You have now completed hardware installation on the HP NetServer LXr Pro units. Go to Part 2 -
Setting Up the HP Rack Storage/8 and Rack Mounting Cluster Devices.
6