Part 2 - Setting Up The Hp Rack Storage/8 And Rack-Mounting Cluster Devices; Setting Up The Hp Rack Storage/8 - HP LC2000r - NetServer - 128 MB RAM Configuration Manual

Part 2 - Setting Up the HP Rack Storage/8 and Rack-
Mounting Cluster Devices
In this step you will both setup the HP Rack Storage/8 units and install them and other cluster devices in the
rack.

Setting up the HP Rack Storage/8

Your HP Rack Storage/8 units will be used for shared storage in the cluster and must be set up for single bus
operation. Although the HP Rack Storage/8 are shipped from the factory configured for single bus operations.
Check their setup as outlined below and change them as necessary.
Single Bus Operation
When cabled as a single bus unit, the HP Rack Storage/8 provides up to eight hard disk drives on a single SCSI
bus. To set up the Rack Storage/8 for single bus operation:
1. Set the Option Switches to the positions shown in the following illustration.
2. Use the bridge cable included as part of the shipped items, and connect the port labeled 1-Out to the port
labeled 2-In.
HP Rack Storage/8 Single Bus Configuration
7
Bridge Cable