HP LC2000r - NetServer - 128 MB RAM Administrator's Manual page 88

Hp netserver remote administrator guide
Hide thumbs Also See for LC2000r - NetServer - 128 MB RAM:
Table of Contents

Advertisement

Appendix A
Pager Code Server Event
The LAN adapter has detected a network fault. Data transmission
21368
was stopped.
The LAN adapter has detected a busy network.
21369
The LAN adapter has detected a performance problem associated
21370
with an inadequate number of receive buffers.
The LAN adapter has detected a performance problem associated
21371
with an inadequate number of receive buffers.
The LAN adapter has detected that the total number of packets
21372
handled during a processing interval has reached a threshold level.
21401
Tape Drive : Problems reading data
21402
Tape Drive : Problems writing data
21403
Tape Drive : Read or write data error
21404
Tape Drive : Faulty media detected
21405
Tape Drive : Tape device may have read fault - call helpline
Tape Drive : Tape device may have write fault - call helpline
21406
21407
Tape Drive : Tape cartridge has reached the end of its useful life
Tape Drive : The tape cartridge is not data-grade
21408
21409
Tape Drive : Attempting write to a write-protected cartridge
21410
Tape Drive : Cannot eject the cartridge while tape drive is in use
21411
Tape Drive : The tape in the drive is a cleaning cartridge
Tape Drive : Attempt to load cartridge of a type which is not
21412
supported
21413
Tape Drive : The tape in the drive has snapped
21414
Tape Device Has Detected Snapped Tape
21415
Tape Device Has Memory Chip in Cartridge Failure
21416
Tape Cartridge Ejected While Actively Writing/Reading
21417
Tape Device Has Detected Read Only Media
Tape Device Has Detected Corrupted Directory On Tape
21418
21420
Tape Drive : The tape drive needs cleaning
Tape Drive : The tape drive is due for routine cleaning
21421
Tape Drive : The last cleaning cartridge used in tape drive has worn
21422
out
21423
Tape Device Has Detected Invalid Cleaning Cartridge
Tape Device Requires Preventative Maintenance
21429
21430
Tape Drive : The tape drive has a hardware fault - reset drive
21431
Tape Drive : The tape drive has a hardware fault - call helpline
21432
Tape Drive : The tape drive has a problem with the SCSI interface
21433
Tape Drive : The operation has failed. Eject media and reload.
21434
Tape Drive : Attempt to use incorrect firmware for this tape drive
21435
Tape Device Humidity Specification Exceeded
Tape Device Temperature Specification Exceeded
21436
21437
Tape Device Voltage Specification Exceeded
Tape Device Predicted to Fail - Call Helpline
21438
21439
Tape Device May Have Hardware Fault - Run Diagnostics
21440
Tape Drive : Autoloader communications fault
21441
Tape Drive : Stray tape detected in autoloader
21442
Tape Drive : There is a problem with the autoloader mechanism
21443
Tape Drive : The autoloader door is open
21444
Autoloader Has Hardware Fault - Call Helpline
84
Event Codes
Severity
WARNING
WARNING
WARNING
CRITICAL
INFORMATIONAL
WARNING
WARNING
WARNING
CRITICAL
CRITICAL
CRITICAL
WARNING
WARNING
CRITICAL
INFORMATIONAL
INFORMATIONAL
INFORMATIONAL
CRITICAL
CRITICAL
WARNING
CRITICAL
WARNING
WARNING
CRITICAL
WARNING
CRITICAL
CRITICAL
WARNING
CRITICAL
CRITICAL
WARNING
CRITICAL
WARNING
WARNING
WARNING
WARNING
CRITICAL
WARNING
CRITICAL
CRITICAL
WARNING
CRITICAL
CRITICAL

Advertisement

Table of Contents
loading

Table of Contents